As a CNC Machined Components Manufacturer, there is some information to share with you. For CNC machining, as long as the CNC processing the equipment has a good reputation and reasonable price, CNC machining has a leading edge in the industrial market, but they often overlook the operation and maintenance of the most important CNC Machined Parts. So how to maintain CNC machining?

　　The key to preventive maintenance of CNC machining is to strengthen daily maintenance. The main maintenance work has the following contents: daily inspection, weekly inspection, monthly inspection, quarter inspection, and semi-annual inspection. CNC machining preventive maintenance is as follows:

CNC Machined Parts

　　1. Daily inspection of CNC machining

　　Its main projects include hydraulic systems, spindle lubrication systems, rail lubrication systems, cooling systems, and pneumatic systems. The daily inspection is based on the normal conditions of each system. For example, when performing the process detection of the spindle lubrication system, the power light should be on, and the hydraulic pump should be running normally. If the power light is not bright, keep the spindle stopped and contact the mechanical engineer. Carry out repairs.

　　2. Weekly inspection of CNC machining

　　The main items include machine tool parts and spindle lubrication systems, which should be properly inspected weekly, especially for machine parts to remove iron filings and external debris cleaning.

　　3. Monthly inspection of CNC machining

　　Mainly to check the power supply and air dryer. The power supply voltage is rated at 180V-220V under normal conditions, and the frequency is 50Hz. If there is any abnormality, it should be measured and adjusted. The air dryer should be removed once a month, then cleaned and assembled.

　　4. Quarterly inspection of CNC machining

　　The quarterly inspection should be carried out mainly from three aspects: machine bed, hydraulic system, and spindle lubrication system. For example, when inspecting the machine bed, it is mainly to see whether the machine tool accuracy and machine tool level meet the requirements in the manual. If there is any problem, you should contact the mechanical engineer immediately. When inspecting the hydraulic system and the spindle lubrication system, if there is any problem, replace the new oil 6oL and 20L separately and clean it.

　　5. CNC processing half-year inspection

　　After half a year, the hydraulic system of the machine tool, the spindle lubrication system and the X-axis should be inspected. If there is a problem, the new oil should be replaced and then cleaned. After thoroughly familiarizing with and mastering the knowledge of preventive maintenance, you must have a deeper understanding and necessary grasp of the causes and treatment of abnormal phenomena in the hydraulic system. For example, when the oil pump does not spray oil, the pressure is abnormal, there is noise, etc., you should know what are the main reasons and what is the corresponding solution.

　　The above is an introduction to how to maintain CNC machining. The correct operation and maintenance of CNC equipment can prevent abnormal machine wear and avoid sudden machine failure. Careful maintenance of the machine tool can maintain the long-term stability of machine tool machining accuracy and extend the service life of the machine tool. Our company provides CNC Machining Services, welcome to come to us.